General Power Supply Circuit Using LM723

This is a one design circuit for power supply that can be used for supply output voltages from 1 to 35V. The line transformer should be selected to give about 1.4 times the desired output voltage from the positive side of filter capacitor C1 to ground. Potentiometer R2 sets the output voltage to the desired value by adjusting the reference input. This is the figure of the schematic circuit;

Untitled-1

In this circuit, the load circuit can be adjust in Rsc. Their using degrees for counting the loader.

?????????? ? ???. ?????

Share to Google Buzz
Share to Google Plus
Share to LiveJournal
Share to MyWorld
Share to Odnoklassniki

Related posts:

Related Posts

  • Untitled-1August 28, 2012 -- Basic Uninterruptible Power Supply Circuit (0)
    This circuit is about basic interruptible power Supply circuit that is consist of regular power supply adapter and battery connection. Here’s the figure of the circuit; This basic system is a “hot”...
  • UntitledSeptember 18, 2012 -- Simple High Current Power Supply Circuit for Ham Radio (0)
    Here’s a design circuit for high-current power supply circuit. Because good performance, size of output 13V-14V depending on the load. And can be choose to create multiple sizes of 5A, 10A, 15A, 20A, ...
  • Untitled-1September 6, 2011 -- Simple Voltage Mirror Circuit (0)
    Here’s a design circuit for applies a second bridge rectifier, D1 – D4, where each transformer rectifier capacity holds graduate C1 and C2. Caused by the resulting strain isolated DC to transformer. W...
  • Untitled-1January 30, 2013 -- Over Voltage Protection Circuit (0)
    Here’s a design circuit that called over voltage protection circuit. This circuit can called as crowbar protection circuit. This circuit is used where we need protection against high voltage surge. Th...


This entry was posted in Power Supply by admin. Bookmark the permalink.